Asbestos board: insulation board and the other sheets people mean
Most people searching for asbestos board have fibro sheet in mind. Insulation board is a different product, and it deserves more caution.
Asbestos board is a loose name for several flat sheet products. And the one you have decides what you should do. The common one is fibro, an asbestos cement sheet. The less common one is asbestos insulation board, which was made for fire protection and sound control.
Two products, one nickname
Fibro is cement reinforced with asbestos fibre. It was used on walls, eaves and wet areas of houses built up to the 1980s. Insulation board is softer and more chalky. It was often fitted where a building needed a fire rating.
In a house you are most likely to meet it around a switchboard, behind a heater, as a liner in a ceiling or in a partition between a garage and the living space. It is much less common than fibro.
Why insulation board needs extra care
Insulation board is less dense than asbestos cement. It crumbles more easily when it is damaged, wet or old. That makes loose fibre more likely when someone drills it or snaps an edge.
Some state rules treat it differently from fibro. Do not assume a homeowner is allowed to remove it. Ask your WHS regulator first, because the answer varies by state and territory.
You cannot identify it by looking
Colour, thickness and a rough surface prove nothing. Newer fire-rated boards can look almost the same as the old ones. Only a sample analysed by a NATA-accredited laboratory can say whether a board is compatible with containing asbestos or not.
Our guide to taking an asbestos sample explains why even sampling should be done carefully, or left to an assessor. The Asbestos Product Guide is a good place to see where each product was used.
What to do if you have a board you are unsure about
Leave it alone. Do not drill, cut, sand, scrape or break it, and do not hang shelves on it. If it is intact and painted or sealed, it is usually safer left in place than disturbed.
If the board is damaged, or you are about to renovate, get it assessed before any work starts. See what a homeowner may legally remove and the difference between Class A and Class B licences. A damaged or crumbling board is a job for a licensed professional.
Frequently asked questions
Is asbestos board the same as fibro?
Not always. Fibro is asbestos cement sheet. Asbestos insulation board is a softer, less dense product made for fire protection. People use the term for both.
Can I tell if a board is asbestos by looking at it?
No. Only a sample analysed at a NATA-accredited laboratory can confirm whether a board is compatible with containing asbestos.
Can I remove insulation board myself?
Do not assume you can. The rules differ by state and territory, and damaged board is a job for a licensed professional. Ask your WHS regulator before you touch it.
Is it safe to leave an old board in place?
If it is intact and sealed, leaving it alone is usually safer than disturbing it. Get it assessed before any renovation work.
Sources
What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.
- Asbestos Safety and Eradication Agency. Asbestos Product Guide: what products contained asbestos and where they were used
- NSW Government. Asbestos in NSW: the NSW Government asbestos portal
- Western Australian Department of Health. Guidance note: Identification of asbestos containing material