Home › Roofing › Asbestos roofing felt and bitumen: what it is and what to do

Asbestos roofing felt and bitumen: what it is and what to do

Most black bitumen on a roof is not asbestos. A small share of old built-up felt was, and the only way to tell the two apart is a laboratory result.

Some old roofing felt did contain asbestos, but bitumen on its own tells you nothing. Plenty of black, tar-like roofing in Australia is modern felt or membrane with no asbestos in it at all. The ones worth a second look are older built-up layers on flat or low-pitch roofs.

This page is about that narrow case. It does not confirm anything about your roof, because nobody can identify asbestos by eye. What it does is help you decide whether the question is live.

What was asbestos roofing felt?

The Asbestos Safety and Eradication Agency's product guide describes it as bituminous roofing felt made by soaking asbestos felt in asphalt. It is also listed as bituminous membrane sarking. The asbestos gave the sheet stability and helped it resist rot.

It was a flexible sheet laid over a continuous surface such as timber or concrete, and it works on any roof shape. It is more common on flat roofs. The guide gives its period of use as the 1900s to the 1980s.

Two to four layers were typically lapped and bonded with hot or cold bitumen. Some surfaces had marble chips, fine gravel or metallic foil pressed into the top coat to resist sun damage.

Where it turns up

The guide lists blocks of flats and apartments on the residential side. On the commercial side it lists larger roofs, public buildings, factories and substations. For a single house, the likely places are different:

  • Flat or low-pitch roofs over extensions, garages and carports.
  • Underneath a later layer of gravel, paint or a newer membrane.
  • Flashings and upstands where the roof meets a wall.
  • Roof decks in older flats, where the felt sits under the finish you can see.

Why bitumen alone proves nothing

The same guide makes the point that non-asbestos bituminous felts, made from materials such as rag felt, paper, glass fibre or hessian, were common and are still widely used. A black, tarry surface could be either. Colour, smell and texture do not separate them.

Age does narrow it. A flat roof on a building from the 1990s or later is far less likely to have asbestos felt than one from the 1960s. But roofs get patched and recovered in layers, so the date of the layer under your feet is what counts, not the date of the house.

When it is worth testing and when it is not

Leave it alone if it is intact, nobody is working on it and nothing is about to change. An undisturbed layer does not need a laboratory fee today.

Test, or treat the layer as asbestos until you know, in these cases:

  • You plan to re-roof, recover or penetrate it for a vent, a flue or solar.
  • The felt is cracked, blistering or crumbling at the edges.
  • You are buying or selling and a report has asked the question.
  • A tradesperson wants to strip it, torch it or sand it.

How the question gets settled

Only laboratory analysis settles it. The product guide itself says sampling and testing may be needed to confirm asbestos. Accreditation by the National Association of Testing Authorities (NATA) is what lets you rely on the result.

Who may take the sample, and whether a householder may do it, depends on the WHS regulator in your state or territory. Check with them first. Do not scrape, cut or lift a corner yourself to see what is underneath.

What not to do

  • Do not strip, grind, sand or torch off old felt to find out what it is.
  • Do not pressure wash a flat roof with old felt on it.
  • Do not bag up scraps with the household rubbish. Asbestos waste goes to a facility licensed to accept it.
  • Do not let a roofer lay a new layer over a damaged one without saying what the old one is.

If the result is positive, removal rules and licence classes are set state by state. The regulator for your jurisdiction is the place to confirm them before anyone picks up a tool.

Frequently asked questions

Is roofing felt asbestos?

Not usually. Modern roofing felt and membranes do not contain asbestos. Older built-up bituminous felt, used up to the 1980s, could be made from asbestos felt soaked in asphalt, so an old flat roof is worth testing before it is disturbed.

Is bitumen the same as asbestos?

No. Bitumen is a binder. Some old felts were made by soaking asbestos felt in it, but bitumen on its own contains no asbestos and a black surface cannot tell you which kind you have.

How do I know if my flat roof felt has asbestos?

You cannot tell by looking. Date the layer, note its condition, and if the roof is going to be disturbed, have a sample analysed by a NATA-accredited laboratory. Check with your state or territory WHS regulator about who may take the sample.

Can I remove old roofing felt myself?

Do not strip it until you know what it is. If it is confirmed or presumed to contain asbestos, what a householder may do is set by the WHS regulator in your state or territory, and the rules differ between jurisdictions.

Sources

What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.

Keep reading